A technician is configuring a PowerEdge R640 that has two PSUs. The tack in which it is being installed has two power distribution units (POUs) No high power such as GPUs are required The user wants as much redundancy protection as possible.
What is the best way to configure the PSUs?

• A. Redundancy Mode sot to 2+0 with each PSU power cord connected to a different POU
• B. Redundancy Mode sot to 1 + 1 with both PSU power cords connected to the same PDU
• C. Redundancy Mode set lo l + 0 with the second PSU stored nearby tor Quick replacement if the first PSU fails
• D. Redundancy Mode set to 1 + 1 with each PSU power cord connected to a different PDU

A technician receives a repurposed PowerEdg server. After racking and cabling the server.
The technician attempts to log into the iDRAC but cannot do so. The default login account has been disabled What method can be used to enable the default login account?

• A. SSH into the iDRAC and run the recadm recreset command
• B. Run the racadm racrset command from the host OS
• C. Run the racada racresetcfg command from the host OS
• D. SSH into the iDRAC and run the racadm recresetcfg command

After a disk rebuild operation, a technician needs to configure the system so that the rebuild process happens faster in the future, even at the expense of stowing users down How should the technician perform this task?

• A. Change the System Profile to Performance in the System BIOS Setting
• B. Change the Rebuild Rate from me iDRAC GUI
• C. Change the Rebuild Rate in the System BIOS Settings
• D. Change the System Profile 1o performance in the iDRAC GUI

A user installed OME on a PowerEdge R640 server. OME has discovered and is currently monitoring another 30 remote PoworEdge 14G servers. Each server has the following configuration.
* 2xCPUs
* 384 GB RAM
* 6x118 drives ma RAID 6 virtual disk
* No hot spare drive
* PERC
* vFlash
* iDRAC9 Express license
At 9 PM on Monday evening, one of the remote servers has a disk failure but stays operational. The administrator monitoring OME does not find out about the issue until 5 PM the following Friday. They place a support call to investigate why OME was not informed about the disk failure before then.
What is the reason for this issue not being reported to OME?

• A. Remote servers are not configured with OME as the trap destination address OME was informed of the issue when remote servers sent alerts at 5 PM Friday.
• B. Remote servers are not configured with OME as the trap destination address OME discovered the issue during a routine status check which is configured to run at 5 PM every Friday.
• C. Remote servers need to have the iDRAC Enterprise license installed to be able to send alerts.
• D. OME only updates its alert database at 5 PM every Friday.

Refer to the exhibit.

A technician tries to apply s BIOS update on a sever through the iDRAC wed interface using the Linux Dell Update Package filo BIOS _2M4CC_LN_2 0 2 BIN. This results in the error shown in the exhibit.
What should the technician do to address this issue?

• A. Extract the Linux Dell Update Package and apply payload file
• B. Re-download the file to replace the corrupted version and reinstall
• C. Reset the iDRAC and reply the update
• D. Download and apply the Windows Dell Update Package tile