Apr 14, 2023 HPE6-A71 Exam Crack Test Engine Dumps Training With 173 Questions
Obtain the HPE6-A71 PDF Dumps Get 100% Outcomes Exam Questions For You To Pass
NEW QUESTION 36
Refer to the exhibit.
An administrator examines theconfiguration of an AP from apboot mode shown in the exhibit.
What can the administrator determine from the configuration?
- A. AP terminated on a non-cluster Mobility Controller.
- B. RAP terminated on a Mobility Master.
- C. RAP terminated on a stand-alone controller.
- D. AP terminated on a Mobility Controller in a cluster.
Answer: D
NEW QUESTION 37
An administrator configures Unified Communications and Collaboration (UCC) heuristics mode on an Aruba Mobility Master (MM). What should be modified in order to send items such as VoIP sessions and monitored information about adds, updates, deletions, and periodic snapshots of those VoIP sessions on the MM or the Aruba Mobility Controller (MC)?
- A. OpenFlow Controller profile
- B. Skype ALG Configuration profile
- C. OpenFlow profile
- D. Mgmt Config profile
Answer: A
NEW QUESTION 38
An administrator supports a RAP to abranch office. Employees at the branch office connect to an employee SSID that allows for split tunneling of the employee traffic. The RAP initially connects to the corporate office controller, but later loses connectivity to it.
Which operating mode should the administrator configure for a secondary SSID to be advertised during the loss of connectivity?
- A. Standard
- B. Always
- C. Backup
- D. Persistent
Answer: D
NEW QUESTION 39
An administrator configures an ArubaOS switch for per-user tunneled node. Which protocol does the switch use to communicate with the Aruba Mobility Controller (MC)?
- A. GRE
- B. SSL
- C. PAPI
- D. IPSec
Answer: A
NEW QUESTION 40
Refer to the exhibit.
An administrator configures a cluster with only the members shown in the exhibit. AP load balancing is enabled.There are no other cluster parameters configured. What occurs when a cluster member experiences a failure?
- A. APs reboot and rejoin the cluster.
- B. APs and clients are fully replicated.
- C. Connected users are de-authenticated
- D. High value sessions are synchronized.
Answer: C
NEW QUESTION 41
An administrator implements a cluster of four Aruba Mobility Controllers (MCs) managed by a Mobility Master (MM). An AP Group is configured with two VAPs and deployed to an AP thatwill connect to the cluster. Each AP contains two radios.
How many GRE tunnels will be built from the AP to the Active AP Anchor Controller (A-AAC)?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
NEW QUESTION 42
Refer to the exhibit.
A user uses a wireless client for a wireless session. Based on theoutput shown in the exhibit for the selected Aruba AP, what is the possible problem with this user's wireless session?
- A. The user misconfigured the Windows Managed Network Settings profile.
- B. The user is associated with a failed 802.1X/EAP authentication
- C. The user is configured for PEAP, but the WLAN profile implemented EAP-TLS.
- D. The AP has reached the limit for number of usersconnected to the radio.
Answer: B
NEW QUESTION 43
An administrator mistakenly configures the wrong VLAN setting on a managed controller's interface. This causes the controller to lose management access to the Mobility Master (MM). The administrator knows that the auto roll-back feature will revert the managed controller to a previous configuration that was used prior to the change.
Which command can the administrator use to validate that the rollback process is successful?
- A. show debug
- B. show switches
- C. show controller-ip
- D. show config status
Answer: B
NEW QUESTION 44
Refer to the exhibit. Anadministrator implements an L2 cluster of Aruba Mobility Controllers (MCs) as shown in the exhibit. An external RADUIS AAA server authenticates clients associated with the Active User Anchor Controller (A-UAC), where the NAS IP address sent from ControllerB is 10.254.1.2.
By default, what happens to the user's session when it is handed over to the Standby UAC (S-UAC) after a failover?
- A. The user's session is disconnected and has to reconnect, but the S-UAC automatically updates the NAS-IP address on the AAA server to record the event.
- B. The user's session remains active, but the AAA server cannot implement RADIUS Change of Authorization (CoA).
- C. The user's session remains active and RADIUS messages can still be processed between the S-UAC and AAA server.
- D. The user's session is disconnected and has to reconnect, and no record of this process is stored on the AAA server.
Answer: B
Explanation:
Explanation
"The Authorization module authenticates clients on the A-UAC and sets the A-UAC IP address as the NAS-IP. External RADIUS servers set the NAS-IP as the A-UAC IP in the client database (Figure 6-17).
This NAS-IP is used later to change client states or attributes.However, when the client moves to a new UAC, the authentication server is not updated. This means that transactions initiated by the authorization server will fail.
To resolve this issue, you should configure each cluster member to use the Virtual Router Redundancy Protocol (VRRP), as described below. This enables interaction between the cluster and the authorization server. "
NEW QUESTION 45
An administrator wants to implement bandwidth limits for guest users to restrict their Internet usage. On the Mobility Master (MM), where would the administrator define these limits?
- A. User role
- B. AAA policy
- C. 802.1X policy
- D. Firewallpolicy
Answer: D
NEW QUESTION 46
Which protocol is used between Aruba Mobility Controllers (MC) and ArubaOS-Switches to negotiate tunneled node?
- A. GRE
- B. PAPI
- C. IPSec
- D. SNMP
Answer: A
Explanation:
Explanation
NEW QUESTION 47
Refer to the exhibit.
An administrator examines the configuration of an AP from apboot mode shown in theexhibit.
What can the administrator determine from the configuration?
- A. AP terminated on a non-cluster Mobility Controller.
- B. RAP terminated on a Mobility Master.
- C. RAP terminated on a stand-alone controller.
- D. AP terminated on a Mobility Controller in a cluster.
Answer: D
NEW QUESTION 48
An administrator wants to use AirWave to manually add devices on the network. Where should the administrator perform this action?
- A. in Device Setup
- B. in AMP Setup
- C. inGroups
- D. in APs/Devices
Answer: A
NEW QUESTION 49
Which VPN component must be configured on the Mobility Master (MM) to allow a RAP to use the built-in certificate to successfully connect to a Mobility Controller (MC)?
- A. VPN username and password
- B. IPSec pre-shared key
- C. CPSec auto-whitelist
- D. IP Address pool
Answer: C
NEW QUESTION 50
Which ArubaOS CLI command can an administrator execute to determine if AP load balancing is enabled in a cluster?
- A. show aaa cluster essid
- B. show ap active
- C. show lc-cluster group-membership
- D. show switches
Answer: C
NEW QUESTION 51
Refer to the exhibit.
An administrator wants to centralize administrative access to the Aruba Mobility Controllers (MC) and Mobility Master (MM). ClearPass is set up and the preferred authentication protocols is TACACS+. Where should the administrator perform this configuration in the MM hierarchy shown in the exhibit?
- A. At the Managed Network level
- B. At the controller levels
- C. At the two campus levels
- D. At both the Mobility Master and Managed Network levels
Answer: D
NEW QUESTION 52
In the WebUI of an Aruba Mobility Controller (MC), where recommended approach for this process generate a tech support file that the Aruba Technical Support team can use to help customers?
- A. Maintenance> Copy logs> download logs
- B. Diagnostics> Technical Support> System Information
- C. Diagnostics>Technical Support> Copy Logs
- D. Configuration> System> Logging
Answer: B
Explanation:
Explanation
References:
Generating a crash Dump:Diagnostics>Technical Support>Copy Crash Files
Generating a tech support file:Diagnostics> Technical Support> System Information
NEW QUESTION 53
Where would an administrator define the split-tunneling mode for a RAP located at a branch office?
- A. the Firewall policy on the RAP
- B. the VAP profile on the controller
- C. the AAA policy on the controller
- D. the Firewall policy on the controller
Answer: A
NEW QUESTION 54
Refer to the exhibit.
An administrator implements the MultiZone feature. The administrator sets up five zones as shown in the exhibit.
* Zone A has six controllers that form a cluster.
* Zone B has three controllers that form a cluster.
* Zones C, D, and E have a single standalone controller each.
A total of 13 VAPs are created across the five zones. A zone needs to accept RAP connections from branch offices. All zones have the same AP Group name. One of the zones will not accept connections from the MultiZone APs.
What could be a cause of this problem?
- A. The number of zones exceeds the maximum limit of four zones.
- B. The number of VAPs exceeds the maximum limit of 12 VAPs.
- C. AP Group names are different for each zone.
- D. RAPs are used in the configuration.
Answer: D
Explanation:
Explanation
NEW QUESTION 55
An administrator moves an AP from Campus 1 to Campus 2. At the Campus 2, the moved AP does not connect to a controller and download an AP Group configuration.
Which process should the administrator perform to reset the AP back to its initial default state?
- A. From apboot mode, execute purgeenv.
- B. From the controller's ArubaOS, execute write erase all.
- C. From the AP's ArubaOS CLI, execute write erase all.
- D. From apboot mode, execute factory_reset.
Answer: D
NEW QUESTION 56
An administrator deploys an Aruba Mobility Controller 7005 to a branch office. The administratoraccidentally disables the console port on the controller. Which controller command should the administrator use to re-enable the console part?
- A. mgmt-user console
- B. console enable
- C. console reset
- D. no mgmt-user console-block
Answer: D
NEW QUESTION 57
A network of Mobility Controllers (MCs) is managed by a Mobility Master (MM). An administrator misconfigures the IP addressing on an MC and the MC loses connectivity to the MM.
How should the administrator fix this problem?
- A. Use the auto-recovery mode on the Mobility Master.
- B. Use the disaster recovery mode on the Mobility Master.
- C. Use the disaster recovery mode on the Mobility Controller.
- D. Restore the previous configuration on the Mobility Master.
Answer: C
NEW QUESTION 58
An administrator creates a user role that department A in acompany uses. Various other roles exist for other departments. All employees connect to the same ESSID, which authenticates to an external AAA server. How should the administrator configure to assign the appropriate roles to the employees?
- A. implement user roles
- B. implement server-derived roles
- C. implement default roles
- D. implement AAA profile roles
Answer: A
NEW QUESTION 59
An administrator implements a standalone controller that runs ArubaOS 8.x. Which feature should the administrator configure to optimize the RF operation for the company's WLAN?
- A. Clustering
- B. Zones
- C. ARM
- D. AirMatch
Answer: C
NEW QUESTION 60
......
HPE6-A71 Exam Dumps Contains FREE Real Quesions from the Actual Exam: https://passleader.briandumpsprep.com/HPE6-A71-prep-exam-braindumps.html
